Latest activity

Zack, yes, nails holding on the deck, no screws. There are 2 screws on the seat rails, but obvious not original due to marks from the...

Hey Zack, in your first seat picture, there's that half dovetail lap joint onto the inwale again!

Rollin, On top of the decks and thwarts, don't forget the seat. This is where I'm sold on it being a Gerrish and no question. The rear...

So, a beak or a biscuit it is.....hmm. A bit of spruce board left about , no need to thin 'er just get the hand hold comfortable...

Over the first weekend of May a few members of the UK Chapter joined forces with some other canoe clubs for a long weekend on the...

I am looking for dimensions for a floor grate for a morris model a type 3. I don't have the original one so i'm looking for width...

This forum is not intended for advertising canoes. The classifieds at https://www.woodencanoe.org/classifieds are much better and the...

Yes, that is known as the mast step for a sailing canoe. The link below describes it along with the other parts. Benson...

Thank you for all that information! We have read through the suggestions and will give it another try once we get the canoe out of the...

This forum is not intended for advertising canoes. The classifieds at https://www.woodencanoe.org/classifieds are much better and the...

Welcome, the Old Town with serial number 159152 is a 15 foot long motor boat so that isn't a good match. Another option was 169152 but...

Hello -- I am new and working on collecting information on my grandfather's beloved OT wooden canoe. It came to my father, who has...

My parents bought a fiberglass Old Town Wahoo sailing canoe in the late 60s. It has all its parts, and an electric motor as well, and...

So, a beak or a biscuit it is.....hmm. A bit of spruce board left about , no need to thin 'er just get the hand hold comfortable...

So, a beak or a biscuit it is.....hmm. A bit of spruce board left about , no need to thin 'er just get the hand hold comfortable...