Latest activity

If it were in my shop, I would remove the worst of the worst planks and replace them with planks from a “donor” canoe of similar patina...

Lattice stock can still be found at some lumber yards. It usually comes in 1/3/8" widths. It works well for the long strips.

To finish this long project report, here are pictures of the fully finished canoe: Here, it's on the left alongside a Chestnut Bobs...

If it were in my shop, I would remove the worst of the worst planks and replace them with planks from a “donor” canoe of similar patina...

If it were in my shop, I would remove the worst of the worst planks and replace them with planks from a “donor” canoe of similar patina...

.. or maybe 73996 16. Maybe proceeded by a 1 too - 173996 ? And am I right in thinking it's an early Otca?

The classic post glass mess. It's often ugly. What I generally do is make sure that I remove any remaining hardened resin that might...

I was sent a pic of the serial # on this 16ft Old Town. I'm thinking it reads '72996 16'. I think it helps to look at the image...

Okay, a philosophy discussion ensues... Please entertain me with your opinions on re-planking this 1927 Old Town 50#er. I'm planning...

I have at least a couple of dozen old Disston hand saws, I only use a few. They all have some rust, even pits, but can be cleaned and...

Welcome aboard Cable.

The information at the link below describes one in a 16 foot long canoe. Good luck, Benson...

To finish this long project report, here are pictures of the fully finished canoe: Here, it's on the left alongside a Chestnut Bobs...

Well, I got the form and luckily the stations were at 12 inch centres. I set about it with a saw and screwdriver to remove the centre...

A very pleasant story, Pat. Thanks . Its a pretty boat . Dave