Help support the WCHA Forums by making a tax-deductible donation!

Router cutter

Discussion in 'Strippers, Stitch-n-Glue, and Other Wood Composite' started by Blighty1, Jan 14, 2007.

  1. Blighty1

    Blighty1 Curious about Wooden Canoes

    I am looking in the canoe craft book. I cannot find any details about the radius of the cutter used for the edge of strips. If the boards are 6mm thick then the cutter needs to be bigger or the edges will be too thin.
    Any ideas.

    Thank you in advance
     
  2. Woodchuck

    Woodchuck Woodworker

    A 1/4" thick strip with a half round edge has to have a 1/8" radius. Some are going to the 3/16" bit to get a less sharp corner on the cove. Personal choice...
     

Share This Page